These RGB LED strip tape lights are very easy to use and also look amazing when working, and you get a forty four buttoned remote control too, which has loads of different options for the LED lights, you sure wont be stuck to try and find a light pattern that will become your favourite, and you can even create and save your own to the DIY buttons, and also you have a good 500cm of light on the strip.
You also get with the lights, a battery for the remote control, a control box for the lights this also has the IR sensor on it, then you have the power adapter that has a cable length of 117cm, with a cable diameter of 0.3cm it has a 0.5cm round connector plug at its end, then you have a short power connector cable that is 17cm in length, that you can use with the two supplied tape connectors, should you want to cut the tape light, and create another set of lights, but of course you will need another power adapter to power them, and this is not supplied.
The RGB LED strip lights are spaced out along the tape at a distance of 3.2cm apart, and they have a diameter of 0.3cm, with their outer casing being 0.5cm square, the tape is very flexible you will be able to place it where you want them, and the 3M sticky backing all along the tape lights back is very sticky, and will keep your light stuck to whatever you stick them on to.
The remote control is nice and large, so making it very easy to use it has a width of 5.5cm in width, and 12.3cm in length and it has a depth of 0.6cm, it is easy to hold in your hand and to use with just one hand and your fingers, the buttons all have the following diameter of 0.8cm, it comes with a pre installed CR2035 battery, all you need to do to activate the battery is, remove the plastic tab which is hanging out of the battery compartment, and then you can use the remote control.
You can use the RGB LED tape lights anywhere be it in your bedroom or living room, or even if you are a DJ you could use them around your equipment, like your Decks or speakers.